Emta Cable production lines have certificates, which are:
ICS.29.060.10 (TS EN 60889) Hard-drawn Aluminium Wire for Overhead Line section,
ICS. 29.060.10 (TS EN 50182) Conductors for Overhead Line Round Wire Concentric Lay Stranded
Emta Cable Tests are below:
Raw materials
All raw materials are supplied from high qualified and approved suppliers. According to the material, required specifications are determined and transmitted to the supplier. Supplied raw material is investigated to control the conformity of the product according to the technical specifications before accepted in the factory.
Conductors
Routine Tests (Emta Cable Test Laboratory)
Sample of individual wires from each length of finished conductor are tested in accordance with major standards like ASTM, IEC, EN, DIN, BS, EN NF-C, UNE and TS regarding customers’ required standard. Individual aluminium and steel wires are tested before stranding.
Aluminium Alloyed Wire Rod
• Surface Finish
• Diameter
• Tensile Strength
• Resistance
• Chemical Analyses
Aluminium Wire
• Surface Finish
• Diameter
• Tensile Strength
• Resistance
Complete AAAC Conductors
• Surface Finish
• Complete Diameter
• Lay Direction
• Lay Length
• Lay Ratio
• Tensile Strength
• Resistance
Sample Tests (Emta Cable Test Laboratory)
Sample tests shall be carried out on the complete conductor to provide compliance with the standards.
The following sample tests shall be carried out:
• Outside view
• Construction
• Diameter, lay length and lay ratio
• Ultimate tensile strength test